There’s a moment after we’ve leveled the rig when the campground finally goes quiet-until a gust hits, someone walks inside, and the wobble reminds us why good stabilizers matter. On a recent run of weekends, we put the Eaz-Lift Camco Telescopic RV Jack set (model 48864) to work under our trailer to see if these steel towers could tame the shimmy without adding hassle to setup.
This pair of jacks adjusts from 16 to 30 inches via a quick pull pin and threaded screw, with a zinc-plated inner tube and a powder-coated exterior for rust protection. They’re rated for a 6,000 lb load and designed for stabilization, not lifting, which is exactly how we used them-under the frame rails to firm things up after leveling.
In this review,we’ll walk through how they handled real campsite conditions-uneven pads,soft shoulders,and a breezy night-along with setup time,build quality,and pack-away convenience. We’ll also touch on where the telescopic design shines, where it doesn’t, and weather this set of two offers the right blend of stability, adjustability, and durability for your RV.
How these Eaz lift Camco jacks fit into our leveling routine
Once we’ve chocked and leveled front to back, these stabilizers are our next move. We place them under solid frame points, set the height with the quick pull pin, then fine‑tune with the zinc‑plated inner tube and screw assembly until they’re snug. The 16-30 inch adjustability keeps us covered on most sites, and the powder‑coated steel stands up to road grime and weather. With a 6,000 lb load capacity and a set of two in the bag, they slot neatly into our routine without slowing setup.
- Slide under the frame and choose a starting height with the pull pin.
- Dial in contact with a few turns of the screw assembly.
- Repeat on the opposite side and recheck for sway before extending slides.
We keep height presets in mind for faster campside setups, which helps us get stable sooner and settle in. The ranges below cover most of our stops,from flat concrete to awkward gravel pads,and they map well to the jacks’ telescopic reach.
| Site | Height | Purpose |
|---|---|---|
| Level pad | 16-18 in | Quick contact; reduce movement |
| Light slope | 20-24 in | Align to frame points |
| Uneven gravel | 24-28 in | extra reach for solid footing |
| Taller stance | 28-30 in | Max range when needed |
Check current price and availability
Key features we noticed adjustability load capacity and stability
Adjustability is the star here: the telescoping design lets us dial in support from 16 to 30 inches in seconds, and the quick pull pin makes micro-height changes painless when we’re chasing that last bit of wobble. The zinc‑plated inner tube and screw assembly feel smooth and deliberate, and once set, the stance stays put. Paired with powder‑coated steel, these jacks shrug off road grime and weather while giving our setup a more planted feel at camp.
- Height range: 16-30 in
- Quick-adjust pin: Fast, simple height changes
- Build: Steel with powder coat + zinc-plated internals
- Capacity: Certified 6,000 lb
- Bundle: Includes two telescopic stabilizers
| Spec | Value |
| Height Range | 16″-30″ |
| Max Rating | 6,000 lb |
| material/Finish | Steel, powder-coated + zinc |
| Quantity | Set of 2 |
| Use Case | RV stabilization |
On load capacity and stability, the certified 6,000 lb rating gives us confidence for stabilization duties, and the broad, sturdy posture helps dampen sway when we move around inside. We’ve had the best results placing the pair near high-flex points and snugging them up-firm, not over-cranked-to take slack out of the suspension.The corrosion-resistant finish is a quiet hero for longevity, making these a reliable set-and-forget support option season after season.
Check price and see today’s deals
Our field notes and recommendations for setup use and maintenance
Setup notes: we had the best results placing these steel, powder-coated stabilizers on firm ground or pads, then using the quick pull pin to land within an inch or two of our target height. With the zinc-plated inner tube aligned to the frame, we snugged the screw until firm contact, then gave it a modest quarter-turn-no more. Remember,they’re for stabilizing,not lifting. On most campsites, the 16-30 inch adjustability covered everything from low curb sites to slightly crowned pads, and the pair worked well when positioned opposite each other near robust frame points.
- Pre-level with your tongue jack first; use these to remove bounce and sway.
- Use pads under the feet to spread load on soft ground.
- Pin first, fine‑tune second: set the pin height, then dial in with the screw.
- Aim for contact, not lift to protect frames and doors from misalignment.
| Adjustable Range | 16-30 in |
| capacity Rating | 6,000 lb |
| Construction | Steel, powder-coated |
| Hardware | Zinc-plated tube & screw |
| In the Box | Set of 2 |
Maintenance recommendations: after travel days, we wipe the screw and inner tube to clear grit, then apply a light dry PTFE spray to the threads; the zinc plating resists corrosion, and a dry lube keeps dust from clinging. Inspect the quick pin for smooth action,touch up any chips in the powder coat,and rinse road salt when coastal or winter driving is involved. For long-term storage, back off tension, collapse to 16 inches, and stow dry to preserve the screw assembly.
- Do: quick visual check each stop; keep threads clean and lightly lubed.
- Don’t: over‑crank to “jack up” the RV; avoid petroleum greases that attract dirt.
- Tip: mark your usual campsite heights on the tube for faster repeat setups.
- Seasonal care: rinse, dry, and touch up powder coat before winterization.
See price, specs, and availability
Pros & Cons
After putting the Camco Eaz-Lift Telescopic RV Jacks (48864) through their paces, here’s what stood out to us-both good and not so good.
| Pros | Cons |
|---|---|
| Wide 16-30 in. height range covers most campsites | Not intended for lifting or leveling-stabilization only |
| Robust 6,000 lb rating inspires confidence | 16 in. minimum height can be tall for low-clearance rigs |
| Quick pull-pin + screw make setup fast and precise | Screw assembly benefits from periodic lubrication |
| Steel build with zinc-plated internals; powder-coated for rust resistance | Powder coat can chip with rough handling over time |
| Set of two offers solid value for basic stabilization | Many RVs feel best with four jacks, not just two |
| Simple, tool-free adjustment in camp | Needs pads/blocks on soft ground to avoid sinking |
Bottom line: We like these for straightforward, no-fuss stabilization with dependable build quality. Just remember they’re stabilizers-not a substitute for a jack used to lift or level your RV.
Q&A
Q: What are the camco Eaz-Lift Telescopic RV Jacks designed to do?
A: They’re stabilizers, not lifters. We use them to take the wiggle out of a parked RV by supporting the frame once the rig is already leveled.
Q: How much weight can they handle?
A: Each jack is rated for a 6,000 lb load capacity. That’s a static support rating-great for stabilization, not for lifting a rig off the ground.Q: What’s the height range and will they fit our RV?
A: They adjust from 16 inches to 30 inches. Measure from the ground to the frame where you plan to place them when the RV is leveled; if you’re within that range, you’re in the sweet spot.
Q: How do we adjust them?
A: It’s a two-step dance: pull the quick-release pin to set the general height, then use the screw assembly to fine-tune until the jack is snug against the frame.
Q: Can we use these to level the RV or change a tire?
A: No.We level first using our usual method (leveling blocks, hydraulic/auto-level, etc.). These jacks go on after leveling to stabilize. They’re not designed to lift or hold the RV for repairs or tire changes.
Q: How many do we need?
A: The set includes two jacks. For most travel trailers and fifth wheels, we prefer two sets (four jacks) so we can stabilize all four corners. For smaller rigs, one set might potentially be enough to calm the bounce where it’s worst.
Q: Where should we place them?
A: Under solid frame points or crossmembers, never under thin sheet metal, bumpers, or holding tanks. We avoid using them directly under axles unless the manufacturer specifically approves it.
Q: Will they help with bounce and sway inside the RV?
A: Yes. Properly placed and snugged up, they noticeably cut down on door slams, footstep vibrations, and general wobble.
Q: How do they hold up to the elements?
A: The outer is powder-coated for rust resistance and the inner tube and screw are zinc-plated. We still wipe them down after wet trips and store them dry to prolong their life.
Q: What’s in the box?
A: Two telescopic jacks.If you like using base pads, rubber mats, or a storage bag, plan to add those separately.
Q: Any setup tips for tricky campsites?
A: On soft or uneven ground, we set a sturdy block or pad under each jack to prevent sinking. We snug them up firmly but avoid cranking so hard that we lift the frame.
Q: Do they work with slide-outs?
A: We don’t use them to support slide-outs. If your RV manual allows slide-out supports, choose products specifically made for slides and follow the manufacturer’s guidance.
Q: What kind of maintenance do they need?
A: Not much. Keep the screw threads clean, occasionally add a light lubricant to the screw, and inspect the pins and welds before trips.Q: Are they compatible with our existing scissor jacks?
A: Yes. We treat these as supplemental stabilization-especially helpful near the entry door or mid-ship-alongside built-in scissor or hydraulic jacks.
Q: Who are these best for?
A: Anyone who’s already leveling their rig reliably and wants a simple, durable way to reduce campsite wiggle. The 16-30 inch range covers most travel trailers and many fifth wheels. If your frame sits especially low or high, check that measurement before buying.
Discover the power
Wrapping up our review of the Camco Eaz-Lift Telescopic RV Jacks, we’re left with a straightforward takeaway: these are practical stabilizers built for everyday use. The 16-30 inch adjustment range with a quick pull pin makes setup simple, while the zinc-plated inner tube, screw assembly, and powder-coated steel provide confidence against wear and rust. Rated at 6,000 lb and sold as a set of two, they’re designed to steady your rig-not to lift it-so they shine at reducing wiggle once you’re leveled and chocked.
If you want uncomplicated stabilization with durable construction and easy height tweaks, these jacks are an easy fit. If you need true lifting or leveling,you’ll want dedicated gear for that job. For stabilization duties, though, this set delivers exactly what it promises.
Ready to take a closer look, check current pricing, and see more details?
See the Camco Eaz-Lift Telescopic RV Jacks on Amazon
Reviews
There are no reviews yet.